![]() ![]() When the port is already open, it will be closedĪnd reopened with the new setting. Port will be reconfigured, even if it’s opened at that time: port ¶ Type: New values can be assigned to the following attributes (properties), the It to None has the effect that its state follows rtscts.Īlso consider using the function serial_for_url() instead of It is common to use one of the methodsĭsrdtr is not supported by all platforms (silently ignored). Note that enabling both flow control methods ( xonxoff and rtscts) ![]() Write() is blocking by default, unless write_timeout is set.įor possible values refer to the list for timeout above. Otherwise wait until the timeout expires and return all bytes that Returns immediately when the requested number of bytes are available, timeout = x: set timeout to x seconds (float allowed).Returning zero or more, up to the requested number of bytes timeout = 0: non-blocking mode, return immediately in any case,.timeout = None: wait forever / until requested number of bytes.Possible values for the parameter timeout which controls the behavior Though, even on these platforms some serial Non-standard values are also supported on some platforms (GNU/Linux, MAC These are well supported on all platforms. dev/ttyUSB0 on GNU/Linux or COM3 on Windows. Port is a device name: depending on operating system. It is not opened when port is None and a successive call The port is immediately opened on object creation, when a port is SerialException – In case the device can not be found or can not be configured.ValueError – Will be raised when parameter are out of range, e.g.inter_byte_timeout ( float) – Inter-character timeout, None to disable (default).write_timeout ( float) – Set a write timeout value.dsrdtr ( bool) – Enable hardware (DSR/DTR) flow control.rtscts ( bool) – Enable hardware (RTS/CTS) flow control. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |